Every furnace call starts with a combustion and carbon monoxide safety check, not just a symptom fix.
Flat-rate pricing quoted after diagnosis, no pressure toward a premature system replacement.
Furnace failures carry a safety dimension — carbon monoxide and gas leaks — that most other hvac repairs don't, so the diagnostic has to start there, which is exactly why furnace repair calls in Gilmer, TX get treated with urgency, not a next-available-Tuesday slot.

Most furnace repair problems give some warning before they turn into a pilot light that won't stay lit, an ignitor that clicks but never catches, or a furnace that runs but blows cold air — catching it early usually means a shorter, cheaper fix.
AAA Pro HVAC built its furnace repair process around one idea: diagnose first, quote honestly, fix it right.
We're licensed, insured, and staffed with techs who've spent years specifically on furnace repair, not general handyman work with an HVAC certificate bolted on.

Every furnace visit includes a combustion analysis and carbon monoxide test before any repair recommendation.
Our crews are trained on standing pilot, hot surface ignition, and electric resistance furnace systems alike.
Diagnosis happens first, and the quoted flat rate reflects the actual confirmed fault.
No-heat calls during freeze warnings get moved to the front of the schedule.
From the first symptom to the final fix, these are the specific furnace repair services our Gilmer-area crews are equipped for.
Standing pilot systems get checked for thermocouple failure, the most common cause of a pilot that won't hold. Techs handling ignitor & pilot light repair carry the specific parts and tools this job calls for, not a generic kit.
A gas valve that won't open or won't seal is tested with proper manometer readings, not just listened to. Techs handling gas valve diagnostics carry the specific parts and tools this job calls for, not a generic kit.
A cracked heat exchanger is a carbon monoxide risk and gets flagged immediately with the furnace shut down if needed. Techs handling heat exchanger inspection & repair carry the specific parts and tools this job calls for, not a generic kit.
We test motor amp draw against rated spec before replacement. This is one of the most requested furnace repair calls we get across Gilmer, TX.
We inspect the full flue run, not just the connection at the furnace. This is one of the most requested furnace repair calls we get across Gilmer, TX.
We test low-voltage circuits before condemning the board. Techs handling thermostat & control board diagnostics carry the specific parts and tools this job calls for, not a generic kit.

Tell us the symptom — no ignition, cold air, gas smell, or error code — and we route accordingly.
We confirm your Gilmer address and a realistic arrival window.
Flat-rate quote follows the confirmed fault, before repair begins.
Most ignition and control repairs finish same-visit.

Tech tested the ignitor's resistance right in front of me and swapped it in under thirty minutes.
Turned out to be a failed gas valve — they caught it with a proper pressure test, not a guess.
They found a hairline crack in the heat exchanger I never would've noticed.
Pilot light kept going out every few hours.

Usually a failing ignitor or a fouled flame sensor — both are testable with the right equipment rather than replaced blind.
We'll walk you through options including repair versus replacement honestly.
Could be a delayed ignition fault, a failed gas valve, or a limit switch issue — a full diagnostic narrows it down.
Yes — our technicians are trained and certified on both fuel types.
Gas odor calls receive top dispatch priority.
No-heat calls during freeze warnings are prioritized across Gilmer, TX.

Whether you're in the heart of Gilmer or one of the surrounding communities, dispatch routes the closest available technician.
☎ Call +1-866-805-8548 for Gilmer Service